0 Introduction
Thank you for using this product.
• Please read the instructions carefully before using the device.
• Do not attempt to dismantle or repair the product yourself as it will invalidate the warranty.
1 Introduction to the product
A Solar panel
B Foot
C Decorative antennas
D Antenna slot
E PIR detector
F Mode button
G Foot space
2 Operation of the dummy camera
Turn the dummy camera over and put the face of the "solar panel" on a piece of furniture. Then press the button for 3
seconds to switch on the lamp. There are different modes available. Simply press the button to choose the mode that suits
you best.
Presentations of the different modes:
Dimmer mode
When someone comes, the light is switched on. After 30 seconds the light will dim after someone leaving.
Classic mode
When someone comes, the light is switched on. After 30 seconds the light will be turned off after someone leaving.
Mode d'avertissement
When someone comes over, the warning flash is activated. After 30 seconds the light will be turned off after someone
leaving.
Shutdown
Note: Each time you press the "mode" button, the light will flash once to inform you of the change.
3 Working
Charging the battery
during the day (6h)
Lighting at night,
switches off 30 seconds
after last detection
A
E
F
B
4. Safety tips
• Incorrect use of the battery could damage nearby items and
cause a fire or serious injuries.
• Keep the batteries away from children.
• Recycle used batteries in line with environmental protection
regulations.
5. Technical specifications
• More than 30 hours of lighting after a full charge (6 hours)
• Solar panel (2A 5V)
• LED power: 5W
• Integrated motion detector
• Distance range: 3M
• Angle of coverage: 120°.
• Replaceable and rechargeable 1800 mAH lithium battery
(included)
• Protection class: IP65
Support : www.chacon.com/support
Chacon S.A Avenue Mercator 2,
1300 Wavre, Belgium
Ref. : 34448
v1.0 210212
C
C
G