Product Setup; Assembly & Installation; Connecting Power - iOttie Easy One Touch Connect Pro Manual De Instrucciones

03

Product Setup

Assembly & Installation
1. Assembling the Mount
A. Connect the Mount Cradle
with the Ball Joint.
2. Selecting a Location
Choose an installation method: Dashboard/ Flat Surface (A) or Windshield/
Curved Glass (B)
Option A
Dashboard or Flat Surface Installation
Choose a mount location before peeling off any films, and make sure
it is flat and free from any dust or debris.
1. Peel off the protective 2. Remove the plastic
film on the Dashboard cover on the Suction
Pad and stick the Cup and press the
pad on the desired Mount firmly onto the
location. Dashboard Pad.
B. Tighten the Cradle Knob.
3. Push the Locking
Lever down to
engage the suction.
Option B
Windshield or Curved Glass Installation
Choose a mount location before peeling off any films, and make
sure it is free from any dust or debris.
1. Remove the plastic cover from the
Suction Cup and press the Mount
firmly onto the windshield.

Connecting Power

! The Easy One Touch Connect Pro is powered via a micro-USB cable. There is no
off/on switch on the device. Once it is plugged in, the device will remain on unless
the vehicle shuts off power when in parking mode.
1. Plug the micro-USB cable into
the USB port on the back of the
Mounting Head.
2. Push the Locking Lever down
to engage the suction.
2. Insert the Car Charger into your
vehicle's power port.
EN 08 / 09