Installation Requirements
1.
The appliance must be installed in accordance with the applicable rules and must only be used in sufficiently ventilated
spaces. Minimum required ventilation rate stipulated in the Dutch "Bouwbesluit" based on NEN1087: > 0.7 dm3/s per m2,
with a minimum of 7 dm3/s. This ventilation rate in the Dutch "Bouwbesluit" is accepted as the minimum required
ventilation rate, also in countries other than the Netherlands. An openable window or louvre is also required. The
requirements for other flued appliances or additional Cosiscoop lanterns in the same room or space must be taken into
consideration when assessing the required ventilation.
2.
WARNING: Ventilation openings must never be blocked or restricted in any way.
3.
The appliance is only suitable for indoor and outdoor use in well-ventilated areas. When used indoors, the room must
measure at least 30 m3 (e.g. 4mx3mx2.5m) to allow sufficient air circulation and correct operation of the appliance. To
convert from cubic feet (ft3) to cubic metres (m3), divide the room volume in ft3 by 35.3. This volume may include adjacent
spaces but these spaces must not be separated by a door. The provided figures apply when using one Cosiscoop lantern in
an indoor space. When using multiple appliances in one room, we recommend using these figures for room space and
ventilation, and multiplying them by the number of appliances.
4.
This appliance must not be placed in bedrooms, other sleeping areas, in close proximity to kitchens or in bathrooms.
5.
Under no circumstances should the appliance inlet or outlet opening be blocked in any way.
6.
DO NOT place objects on top of the appliance.
7.
DO NOT place objects or fuels in the fire.
8.
Make sure the appliance is placed on a flat, stable and non-combustible surface.
9.
The appliance creates warm air currents, and these currents could heat wall surfaces and other objects.
10. Always place this appliance at least one metre (1000 mm) from non-combustible objects. Nothing can be positioned less
than 1000 mm above the appliance. Combustible materials should not be placed near the appliance; the minimum distance
is 1500 mm.
11. DO NOT burn any foreign materials on this fire.
12. Due to the nature of this product, the surface could be very hot. Care should be taken when operating the appliance.
13. Never leave children and pets unattended with this appliance.
14. Make sure you have a fire blanket and powder extinguisher in your home before you use the appliance. In case of fire,
immediately place the fire blanket around the appliance and make sure the flames are not exposed to oxygen. If necessary,
extinguish the fire using the powder extinguisher. Never use water or foam extinguishers for fuel fires.
15. For assistance or additional information, please contact the supplying retailer.
Installation Cosiscoop
1.
Unpacking the appliance: remove the outer packaging, and read these instructions COMPLETELY before continuing to unpack
or install this appliance. Lift off the remaining packaging and remove the contents of the box. Please dispose of all packaging
materials in accordance with your local recycling procedures.
2.
Install the appliance by following the requirements mentioned under 'Installation Requirements'.
3.
Unpack the glass and pebble stones and place them on top of the appliance.
Connecting to a Gas Cartridge
•
If the gas cartridge inside the appliance is empty, then please read "Removing the Gas Cartridge".
•
Remove the glass and pebble stones before placing the gas cartridge. Only use 190g pierceable gas cartridges with safety
valve, as mentioned in the technical specifications.
•
This appliance is equipped with a sealing washer. Check if the sealing washer (between the appliance and the gas cartridge)
is present and in good condition before connecting to the gas cartridge. Be careful when touching the sealing washer; there
is a needle inside.
•
DO NOT use the appliance if the seal is damaged or worn.
•
DO NOT use an appliance which is leaking, damaged or which does not operate properly. Please contact your supplying
retailer for assistance.
•
Only change gas cartridges outdoors or in well-ventilated places away from naked flames, other ignition sources and other
people.
•
Close the control valve by turning the knob clockwise (OFF).
•
Keep the appliance upright while performing the following steps:
1. Unscrew the cartridge cover clockwise;
2. Place the gas cartridge in the cartridge cover;
3. Screw in the cartridge cover anticlockwise. See picture below. You will hear a 'click' once the gas cartridge has been
correctly installed.
6