In Sink Erator involve Serie Manual Del Usuario página 5

2
INSTALLING THE FAUCET -
a
NOTICE
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
b
C
An assistant may be needed to hold
the dispenser head in place
while securing the dispenser.
8
Hot100/Hot150
Hot100/Hot150
Unpack dispenser components.
On a firm, flat surface, carefully
straighten the copper tubing using
hands only.
Hot100/Hot150
Feed tubes down the hole in
the sink or countertop until the
base is at rest on the sink or
countertop surface.
Hot100/Hot150
From under the sink, place the
rubber washer, plastic spacer and
semi-circular mounting plate onto
the threaded stud.
Place long nut onto the threaded
stud. Make sure faucet head is
at the desired angle. Tighten the
long nut until snug, while ensuring
the semi-circular mounting plate
extends beyond the sink hole.
Do not over tighten long nut. May cause
damage to faucet.
For sinks thicker than 1" the plastic spacer
is not required
Fiber
Washer Wing Nut
3
MOUNTING THE TANK
a
NOTICE
Property Damage: Tank must be located
within 16" of faucet and within 30" or less
of a standard grounded outlet. DO NOT extend
plumbing or electrical lines.
b
Leave 1/4" for
hanging tank.
1
Mount tank vertically in an area that
allows clearance on the underside of
the tank for drainage, if necessary.
DO NOT over tighten screws.
4
CONNECTING FAUCET TO TANK
a
(1)
1 2
1
2
3
NOTICE
Property Damage: Pinched or blocked water
lines may cause damage to the dispenser tank.
Check to make sure tubes are connected
properly and are pushed down as far as possible.
3
Select a spot under the sink to mount
Tank must be
tank vertically within reach of both
mounted level
plumbing and electrical connections.
to ensure
The tank should be within 16" or less
proper operation.
of faucet water lines and within 30"
or less of a standard grounded outlet.
While holding tank in place on
the spot selected for installation,
use a pencil to mark locations for
2 hanging screws.
Screws provided are for use in wood
studs or cabinets only. Use wall anchors
2
(not supplied) for installation into drywall.
Pre-drill 1/8" pilot holes at marks.
Turn screws into pre-drilled holes,
leaving 1/4" exposed.
Hang the tank on the screws.
Tighten the screws with only 1/2
3
turn clockwise.
Without depressing the gray button,
place the snap-connect fitting at
(2) (3)
the end of the blue 1/4" tube onto
the left fitting on the tank, pushing
until it clicks into place. (1)
Slip the flexible white 7/16" tube
over barbed middle fitting and slide
down approximately 1/2". (2)
Slip the clear 5/16" tube over the
far right smooth fitting and slide
down approximately 1/2". (3)
Visually check for pinched or
crimped tubes.
Hose clamps are not needed for any
of the connections.
Fiber
Washer Wing Nut
Bra
Plastic
tube
Brass Nut
Ferrule
B
Brass
Plastic
tube
Plastic
tube
9