Maintenance - Pond Boss 52543 Manual Del Usuario

Step 8. Add the tubing adapter to the hole on the
based of the spillway by using the coupler and
the gasket on the interior of the spillway and the
tubing adapter on the exterior of the spillway.
Step 9. Place the bio-balls inside the bags into the
base of the spillway.
Step 10. Place the filter pad over the bio-balls.
Step 11. Attach the clips to the cover by sliding
into place and clip the cover to the top of the
spillway.
Step 12. Connect a pump to the spillway by
connecting tubing to the outlet of the waterfall
pump and the tubing adapter on the inlet of the
waterfall spillway. Use a hose clamp if desired.
Disguise the spillway with rocks or natural
materials for a professional look. Add water to
pond basin where the waterfall pump is located.
NOTE: Tubing, hose clamp, and waterfall pump are
not included.
Step 13. Connect the pump into a properly
grounded electrical outlet.
NOTE: Pump is not included.

MAINTENANCE

• The waterfall spillway may require cleaning from time to time for optimal
performance.
• Before cleaning, always disconnect the pump connected to the spillway from the
power source.
• Occasional cleaning of the filter pad will be necessary to ensure the proper
funcioning of the spillway. It should be removed and washed with clean water when
6
11
VISIT WWW.THEPONDBOSS.NET FOR PRODUCT INFORMATION AND TIPS.
8
9
12
GFCI
13
oulet
Spillway
Bio-balls
10