Sebson SS B Instrucciones De Manejo página 5

immediately dis-advise the start-up of this product! Please remove all packaging material of this product before the
first start-up an and check the content for completeness!
Intended use:
This SEBSON brand corner shower shelf is suitable for storing bathroom utensils, for example. This product can be
drilled and fixed with the mounting adhesive.
Scope of delivery:

1 Shower corner shelf

2 screws and 2 dowels

1 tube of mounting adhesive

2 adhesive tapes
General safety information:
Danger:
The assembly adhesive can cause serious skin and eye irritation! Avoid direct skin and eye contact by
wearing suitable protective clothing such as protective glasses or safety gloves! If the adhesive gets on the skin,
wash the affected area immediately with soap and water and consult a doctor if the symptoms persist! If the
adhesive gets into the eyes, rinse them immediately with plenty of water and consult a doctor!
In this case, contact lens wearers should remove the contact lens immediately and rinse the eye and contact lens
thoroughly afterwards!
Danger:
If the glue is accidentally swallowed, wash out your mouth with plenty of water and drink plenty of water
afterwards! In case of complaints such as nausea and vomiting or headaches, consult a doctor immediately! There
is a danger to life through poisoning!
Danger:
Keep this product away from children and animals! The packaging contains small parts that can be
swallowed! There is a danger of suffocation! The adhesive included in the scope of delivery can cause serious skin
and eye irritation for children and animals as well as poisoning by swallowing the adhesive!

The manufacture does not accept any responsibility for injuries or damage resulting from improper use of
this product!

We reserve the right to make changes to the product, the packaging or the operating instructions as well as
printing errors.
General instructions for installation:
Choose a base or mounting surface that will hold the weight of the product permanently and reliably. The
manufacturer is not responsible for damage caused by the selection of an unsuitable mounting surface!
Installation by drilling (see Fig.1):
Attention:
Before drilling the mounting holes, make sure that there are no gas, electricity or water pipes at the
drilling location that could be damaged by this!
The maximum load capacity using this mounting method is approx. 10-15kg!
5