Klarstein 10034153 Manual De Instrucciones página 59

Menu item Level 2
Press the SET button to move to level 2. Press the [-] button to move to the next menu
item.
MANUAL: Fire power is not set automatically in this mode.
ECO: Heating is controlled by the temperature sensor. When the preset temperature is
reached, the heater runs at the lowest output.
ECO-STOP: The heating is controlled by the temperature sensor. When the preset
temperature is reached, the heater stops working. As soon as the temperature is 2 °C
lower than the preset temperature, the heating starts again.
Press the SET button to move to levels 2, 3 and 4. Press the [-]
button to move to the next menu item. The example on the right
shows the weekly timer. In this case, the heating is switched on
automatically at 7:30 a.m. on Monday and switched off at 12:50
p.m.. At 15:20 the heating is switched on again, at 21:40 it is
switched off. Note: The time of S1, E1 must be before the time
of S2, E2, otherwise the set time is invalid.
Press the SET button to move to Level 2 and Level 3. Press the [-] button to move to the
next menu item. This function allows you to set the on and off times of the screw engine
and the speed of the exhaust engine at each firing level during operation. Note: If you
wish to make changes here, contact qualified personnel!
Press the SET button to move to level 2. Press the [-] button to move to the next menu
item. This function allows you to set the switch-on and switch-off time of the screw
engine and the speed of the exhaust engine in each ignition phase, as well as the
temperature for the ignition point. Note: If you wish to make changes here, contact
qualified personnel!
Level 3 Level 4
Hour
S 1 & 2 = ON
E 1 & 2 = OFF
Minute
EN
59