Good Earth Lighting WL1176-BK2-00LF1-G Manual Del Usuario

Read entire installation procedure before you begin and save instruction for future reference
1. Suitable for wet locations
2. Do NOT look directly at LED light sources.
3. The LED modules used in this fixture are not serviceable.
4. Do not use this product if damaged or missing parts.
FCC STATEMENT:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications
to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment
has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that the interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1)
Reorient or relocate the receiving antenna. 2) Increase the separation between the equipment and receiver. 3) Connect the equipment into an outlet on a
circuit different from that of the receiver. 4) Consult the dealer or an experienced radio/TV technician for help.
DO NOT plug-in fixture prior to installation. Select a mounting location within 5 feet of an electrical outlet.
Operation
Adjust build-in handle up to 90 degree. Adjust and rotate the light as needed. Tighten
the screw knobs for light head stability.
Adjustable light head
Tête de lampe réglable
Cabeza de luz ajustable
Adjustment knob
Bouton de réglage
Pomo de ajuste
LED
LED
LED
Adjustable stand
Support réglable
Base de soporte
ajustable
ENGLISH
WARNINGS & CAUTIONS
5. Route and secure the cords so that they will not be pinched or damaged.
6. Do not use an extension cord: Use power strips with integral overcurrent protection.
7. Operating environments ranging from -4° to 104°F (-20° to 40° C). Prolonged exposure
to extreme temperatures will reduce the life of this product.
90°
Lampe de travail à DEL enfichable de 18 cm se repliant à plat
Luz de trabajo OPP LED enchufable de 18 cm que se pliega plana
Actual hardware may differ from illustration.
Les éléments de fixation réels peuvent être
différents de ceux de l'illustration.
Es posible que los herrajes reales difieran de los
de la ilustración.
Insert plug into an electrical outlet.
7" Fold Flat LED Plug in Work Light
Model / Model / Modelo #: WL1176-BK2-00LF1-G
ON/OFF Rocker Switch
Interrupteur
Marche/Arrêt basculant
Interruptor oscilante de
ENCENDIDO y APAGADO
Power cord
cordon d'alimentation
Cable de alimentación
(Page 1)
(Page 2)
(Página 3)