FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subjected to the
following two conditions:
(1) this device may not cause harmful interferences and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with limits for a Class B
digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide rea-
sonable protection against harmful interference in residential installations. This
equipment generates, uses and can radiate radio frequency energy, and if not in-
stalled and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment doescause interference to radio or television equipment recep-
tion, which can be determined by turning the equipment on and off, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Move the equipment away from the receiver.
- Plug the equipment into an outlet on a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/television technician for additional
suggestions.
You are cautioned that any change or modifications to the equipment not express-
ly approved by the party responsible for compliance could void your authority to
operate such equipment.
All manuals and user guides at all-guides.com