POWER SUPPLY
The device works with:
• Set of 4 rechargeable NiMH C-type batteries, which is attached
to the underside of the unit.
Charger included.
FUNCTIONS
Horizontal planes: Place the device in the self-leveling range (± 5
°), on a plane or on a tripod or a wall mount.
Vertical planes: Place the device on the flat side, inside the self-
leveling range (± 5 °).
• Press the button (A) briefly to switch the device on
If the LED (a) blinks, the remaining battery capacity is
insufficient. They have to be recharged or replaced.
• The device is set in automatic mode
The beam will blink until the unit is in the self-leveling range.
Then, the beam rotates at 600 revolutions / minute. If the unit
is outside of the self-leveling range (± 5 °), the laser beam
and the LED are flashing. Put the device back into the self-
leveling range (± 5 °).
SPEED FUNCTION
To change the speed, press the button (D):
• 1 time: the beam is fixed at 0 r / min
• 2 times: the beam rotates at 60 rev / min
• 3 times: the beam rotates at 120 rev / min
• 4 times: the beam rotates at 300 rev / min
• 5 times: the beam rotates at 600 rev / min
• for progressive moves of the laser point at 0 rpm, press the
buttons H or G.
SCANNER FUNCTIONS
To access the scanner function press the button (C).
If pressed one more time, the projected beam will have a width
of 10 °, 45 °, 90 ° and 180 °.
To move the laser beam progressively, press the buttons H or G.
TILT-FUNCTION TO SIGNAL UNFORESEEN ACCIDENTAL
MOVEMENT OF THE UNIT
If the unit in the self-leveling mode, press the button (B) to
activate the TILT function. The LED (b) blinks slowly, after 30
seconds fast, and then stays on.
• If the unit is accidentally moved, the laser beam stops and
flashes.
• Switch the instrument completely off and on again by pushing
the button (A). The TILT function is disabled.
SLOPE FUNCTION (INCLINATION)
Put the device in a horizontal position to project a horizontal plane.
• Press the button (M)