Turning On/Off - Bubble BXLAMP01 Manual De Usuario

USER GUIDE
Compatibility
This product is compatible with Bluetooth enabled mobile phones and devices.
Charge
1. Connect the speaker to PC/Laptop/Mac or any 5V USB adapter (not included) by the
included USB cable.
2. A red LED turns ON during charging, and it turns OFF after the device has been fully
charged.
3. Unplug the USB cable after the device has been fully charged.
4. A red LED twinkles in case of low power (<21%), and it emits a warning sound.

Turning ON/OFF

Hold the power button pressed for approx. 2 seconds to turn on. You would hear a starting
chime.
Hold it again for approx. 2 seconds to turn o .
Pairing
1. Turn on the speaker to start pairing. After 3-4 seconds, you would hear a chimed
Bluetooth sound.
2. Activate the Bluetooth function on your mobile phone or any Bluetooth device, search
the speaker and select the name "BXLAMP01". Then, connect the speaker to the device
by Bluetooth pairing
3. The Bluetooth sound will be chimed once more after pairing.
Note:
1. Keep the range of 1 meter when pairing. If the pairing was not successful, turn o the speaker
and re-pair again.
2. After successful pairing, paired devices will remember each other so there is no need to pair
them again unless pairing information is deleted.
3. To pair with a new device, follow steps 1-3 above after disconnecting the lamp from the
existing device.
TWS (True Wireless Stereo) Function:
Pairing one mobile phone with 2 speakers together
1. Make sure you have 2 BXLAMP01 speakers at your hand and turn them on together. Then
double click the "Power" button of both speakers quickly. Both speakers will enter into
pairing mode to pair with each other first.
2. Wait for around 5-10 seconds until both speakers "beep" once in sequence, which means
both speakers have already been paired with each other.
3. Then, activate the Bluetooth function of your device and pair with Bluetooth name
BXLAMP01. You will enjoy music in True Wireless Stereo sound from two speakers
simultaneously.
Notes:
1. can be displayed when there are 2 BXLAMP01 speakers available only.
2. To disconnect an existing TWS connection, double click "Power" button of one speaker. The
sub-speaker will be disconnected and the host speaker will keep playing music.
3. If you want to establish a TWS connection with a 2nd speaker after your device was already
connected to one speaker, please long press" power "button to disconnect from your existing
paired device, then follow above steps 1-3.