Cosco CV014 Guia Del Usuario página 9

Using Your Stroller
To Install Designer 22 Infant Car Seat
WARNING
To avoid serious injury:
• Use ONLY Designer 22 infant car seats with the Travel System.
• Please refer to the manufacturer's instructions for the use of your infant
car seat.
• ALWAYS use child's tray when car seat is installed.
• ALWAYS install car seat facing to the rear of the stroller.
• ALWAYS use the restraint system in the car seat.
• Place adapter bar in storage position behind seat back when not in use.
1. Remove adapter bar from behind seat
back.
Recline seat back to lowest position.
Close canopy.
2. Insert the rigid end of adapter bar
into hole inside stroller frame. Move
fabric to get better access to the hole
inside the frame. Push in spring end
and insert into the hole on the other
side. Test to make sure bar is securely
installed.
NOTE: Make sure no fabric is caught
between the ends of the adapter bar
and holes in frame.
All manuals and user guides at all-guides.com
(Car Seat not included)
1
2
7