Fullwat CMF-7C Serie Manual Del Usuario página 23

Códigos de fallo
Error code
Polarity reverse /
output short circuit
Non battery link
Faulty battery
Over voltage
Over temperature
Note
Solid
:
Frecuently asked questions
How do I know if the battery is charged?
The charger's FULLY CHARGED LED will illuminate (solid). Alternatively for flooded batteries you can use a
battery hydrometer A reading of 1.250 or more in each cell indicates a fully charged battery.
I have connected the charger properly but the 'CHARGING LED 'does not come on
In some cases batteries can be flattened to the point where they have very little or no voltage. This can
occur if a small amount of power is used for a long time. For example a map reading light is left on for a
week or more. 7-stage chargers are designed to charge from as little as 2.0V for 12V charger and 4.0V for
24V charger. If the voltage is lower than 2.0V and 4.0 V use a pair of booster cables to connect between two
batteries to provide more than 2.0V and 4.0V to the battery being charged. The charger can then start to
charge the battery and the booster cables can be removed.
Fully
Charging
charged
LED
3
Fault LED
LED
Flash
Cause
Check clips are not
Short circuit or touching each other
reverse connection or check the clips are
of the clips correctly connected
to the battery
Please choose the
Non battery link right battery type for
connection
Bulk charging has
Battery is faulty and
timed out and
may need to be
stopped after 24
replaced
hours
Disconnect the
The 12V battery
charger and check
voltage is above
the battery voltage.
17.5V. The 24V
This charger is
battery voltage is
suitable for 12V or
above 35V
24V batteries only
Internal temperature Turn off charger and
is above 65 +/-5 allow to cool
Extinguish
Remedy
Bulk charging
3