Emptying The Appliance; Cleaning, Care & Maintenance; Troubleshooting - Buffalo GL346 Manual De Instrucciones

Emptying the Appliance

GL346/GL347/GL348/GL349
Drain the appliance by using the tap to empty
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
De-scaling
For the best water quality, Buffalo recommend that a water filter is installed to the mains water supply,
particularly in hard water areas. Doing so will reduce the build up of limescale and contaminants in the
water tank thus maintaining energy efficiency and prolonging the life of the appliance.
To de-scale the appliance:
1. Pour a solution of de-scaler and water into the appliance.
2. Brush the interior gently with a soft bristled brush.
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back On to flush out the system. Flush out the system
thoroughly to remove any de-scaler residue.
5. The appliance is now ready for use.
Note: Use a suitable de-scaler and always follow the instructions on the
container.
BUFFALO recommend that this appliance is de-scaled every 3 months or more
often in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.

Troubleshooting

Fault
The unit is not working
Power light comes on
but water does not
reach temperature
The tap is leaking (for
GL346 series)
Water not dispensing
(for HF150 series)
GL346-GL349_HF150-HF153_ML_A5_v6_20210930.indb 5 GL346-GL349_HF150-HF153_ML_A5_v6_20210930.indb 5
Drain the appliance with hand over the hand sensor
until empty
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Thermal fuse has activated
Thermostat fault
The tap has become loose
Sensor not detecting the cup
HF150/HF151/HF152/HF153
Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Reset Thermal fuse (see page 4)
Call BUFFALO agent or qualified technician
Tighten the tap handle
Not suited for glass cups, so ensure the cup
used is opaque
UK
5
2021/9/30 17:16 2021/9/30 17:16