Wireless charging
If your phone has Qi wireless charging
capability you can use the charging
panel on the top of the Daybreak to
charge it.
Please Note: Wireless charging is likely
to interfere with radio reception
therefore we advise you not to try
listening to FM radio during charging.
1. Centre* your smartphone on the
cross in the middle of the
charging panel (1).
2. The
wireless charging icon will be displayed in the bottom right corner of the
LCD panel while your phone is charging and the battery charge status can be
seen on your phone's display.
Please Note: Your phone will not charge when the Daybreak is in backup mode (not
being powered by the power adapter).
If problems occur when charging or if charging does not start:
• *Normally your smartphone should be centred on the charging pad as shown.
However some phones may need to be placed slightly off centre. As the built-in
wireless receiver may not be centred inside the phone. This varies by brand/model.
• Remove your smartphone from its case if the thickness of the case exceeds
5mm or if it contains metal.
• The charging time varies depending on the charging capacity of the battery and
its current residual capacity.
• The components may heat up during the charging process. They will slowly cool
down again after the charging process.
USB charging ports
1. You can charge two external devices by connecting them to the USB charging
ports (15 & 16) on the back of the your Daybreak.
2. Your devices battery charge status will usually be shown on it's display.
• There may be some radio interference while charging.
• Please do not try to charge the same device using the wireless charging function
and one of the USB charging ports (15 or 16) at the same time.
www.iboxstyle.com
ENTER
INFO
SCAN
MENU
PRESET
Daybreak | 14