Installation Instructions - Danby DFF092C1BSLDB Guía De Utilización

Remove exterior and interior packings, wipe the
outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Avoid placing the
unit in a narrow recess or near any heat source, direct
sunlight, or moisture. Let air circulate freely around
the unit. Keep the rear of the refrigerator 2 inches
away from the wall.
Location
1) Select a place with a strong, level floor.
2) Allow 2 inches of space between the back of the
refrigerator and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
The refrigerating system in this refrigerator is a
"Frost Free" system. This type of system requires no
user intervention (i.e. defrosting) other than selecting
required cooling temperatures and the usual care and
maintenance.
To avoid vibration, the unit must be set level. This is
accomplished by adjusting the front leveling leg,
located under the refrigerator.
NOTES:
This appliance is intended for FREE-STANDING
•
INSTALLATION ONLY, and is NOT intended to
be built-in.
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
• Before connecting this appliance to electrical
power supply, leave it to stand for approx. 24
hours, which will reduce the possibility of mal-
function in the cooling system due to transport
handling.
• This appliance is approved for INDOOR USE
ONLY and is NOT intended for outdoor operation.
IMPORTANT:
AMBIENT TEMPERATURES BELOW 50º F (10º
C) WILL AFFECT THE OPERATION OF YOUR
REFRIGERATOR. WHEN THE UNIT IS PLACED
IN AN AREA WHERE THE TEMPERATURE
DROPS LOWER THAN 50º F (10º C), SET THE
TEMPERATURE CONTROL SELECTORS TO
"MAX" IN BOTH THE REFRIGERATOR AND
FREEZER SECTIONS.
NOTE:
IF THE UNIT IS UNPLUGGED, HAS LOST
POWER, OR IS TURNED OFF, YOU MUST WAIT
3 TO 5 MINUTES BEFORE RESTARTING THE
UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE REFRIGERATOR-
FREEZER WILL NOT START.
2