Pc Setup - jWIN JV-DTV23 Manual Del Usuario

PC Setup

You can adjust horizontal/vertical position, clock, phase, and auto-configure, reset as you prefer.
Press the MENU button and then
D D
Press the G G button and then
D D E E
/
Press the F F / G G button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right and up/down as you prefer.
Clock
This function is to minimize any vertical bars or stripes visible on the screen background. And the horizontal screen size
will also change.
Phase
This function allows you to remove any horizontal noise and clear or sharpen the image of characters.
Auto-configure
This function is for the automatic adjustment of the screen position, clock and phase. The displayed image will disappear
for a few seconds while the Auto-configuration is in progress.
Reset
This function allows you to return to the good picture reproduction programmed at the factory and cannot be changed.
Note : Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust your
monitorÕs position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
WXGA
To see a normal picture, match the resolution of RGB mode and selection of XGA mode.
All manuals and user guides at all-guides.com
button to select the Special menu.
/ E E
button to select the desired picture item.
SPECIAL
Language H-Pos. 0
CSM V-Pos. 0
PC Control Clock 10
WXGA Phase 15
Set ID Auto
Reset
()OO}{OOOKOOMENU
EN
27