Installation And Start-Up - Glatz Ambiente NOVA Manual De Instrucciones Y Opciones

Installation and start-up

7
7.1 7.2
7.3
7.4
5x
8
8.2
8.3
8.1
9
9.2
9.1
Attaching the umbrella
1. Place the umbrella onto the upright pole.
2. Fasten umbrella pole tightly to the stand-
pipe using 2 washers and 2 cylinder head
screws (supplied with the standpipe). To
insert the screws, move the locking bar to
one side.
3. Align the umbrella into its final position
4. Fasten the umbrella firmly by tightening
the 5 hexagonal screws.
!
The umbrella is very heavy. Work as a
trio and hold the umbrella securely.
Adjusting the locking mechanism
1. Move the locking holes against each
other, so that the locking bar can only
penetrate the top plate of the rotary unit
while standing on the second.
2. Loosen the 2 M6 x 12 stud bolts, lower
the locking unit and locking bar through
the upper locking hole. When the locking
unit stands on the second plate (8.1), the
assembly height is correct. Tighten the
2 M6 x 12 stud screws firmly
(use a ball screwdriver).
3. Press the plate downwards until the
spring reaches approx. 2.5 cm and tighten
the 2 M6 stud bolts.
!
Correct pre-tension makes it easier to
rotate the umbrella.
Completing the assembly
1. Lower the upright pole cover.
2. Mount 2 baffles (short above, long below)
3. Check proper functioning.
!
Check all screws regularly to ensure
they are tight, retighten if necessary.
28 29
Utilisation
Locking lever
Upright pole cover
Swivel adapter
1
Rotating the umbrella
1. Release the locking lever upward.
2. Rotate the umbrella carefully.
3. Push down the locking lever.
4. Move the umbrella over and back
carefully until the locking mecha-
nism clicks into place.
5. Push the locking lever in fully.
!
Avoid collisions when rotating the
umbrella. The umbrella must be
locked correctly again in the new
position!