Assembly Of The Lite-Ex® Pl 10E H; Getting Started; Battery Replacement - Pepperl+Fuchs Ecom Lite-Ex PL 10e H Instrucciones De Uso

3.1 Assembly of the Lite-Ex® PL 10e H
Cap
Battery adapter
LED housing
Disc

3.2 Getting started

The supplied batteries must be inserted to begin with
(outside the Ex-area). In order to be able to use the lamp
in the Ex-area it must be ensured that the lamp head and
the body of the lamp are screwed together tightly. The lamp
can then be switched on by lightly rotating the yellow ring
switch clockwise.

3.3 Battery replacement

The batteries should be replaced if the level of luminance is
no longer deemed to be satisfactory.
It is advisable to change all 3 batteries at the same time.
Only the appropriate, approved types of batteries may be
used (see Ex-Safety Manual, table with approved batteries).
To replace the batteries turn the left-hand side cap (which
bears the „ecom" inscription) in the direction of the arrow
and then remove the entire battery adapter (see fig. 2).
You can then remove and exchange the batteries.
After inserting the new batteries (while observing the correct
Ring switch
Sealing ring 22.5 x 2.0
Lamp head
Sealing ring 27.0 x 1.0
Flashlight body
Sealing ring
22.5 x 1.5
Fig. 1
5