Rehabmart Paramount PCC Manual Del Usuario página 8

Attach corner cover (B) to mounting bases (C) by guiding corner cover flanges into slide channels of mounting
6
bases as shown in figure 6.1. Note: It may be necessary to slide covers (A) apart to allow corner cover to fit. After
corner cover is attached, slide covers under corner cover until cover flanges contact flanges of corner cover.
Slide apart covers (A) and align tabs of cover joint (D) with channels in mounting base (C) and attach as shown in
figure 6.2. Slide covers back for a flush fit.
Attach end caps (E) to mounting bases (C) as shown in figure 6.3.
fig 6.2 fig 6.3
fig 6.1
FLANgES E
A C
A
C
C
A
A
TaBS
A
ChANNELS
B
D
8 of 24
ISSUED: 04-23-08 SHEET #: 120-9046-1