Installing the panel reader and antenna
5
Example installation
In this example, a single panel reader is being used as part of a
weighing system. The panel reader and antenna are mounted to
a cattle crush and the panel reader is connected to an indicator
and load bars. When the animal enters the cattle crush, its EID
tag number is scanned by the panel reader and sent to the
indicator.
Installation information
The panel reader and antenna can be mounted onto a flat
surface (timber rails, concrete), or onto metal pipe-work, using
the hardware supplied. If you have a large antenna, the panel
reader can also be mounted directly on the back of the antenna.
When mounting the antenna, do not damage it by drilling through it or piercing the surface with a screw.
Use the mounting holes provided.
Factors to consider:
The panel reader and antenna should be installed on the outside of a crush/chute, weigh crate or drafter so that it is
•
not damaged by animal movement.
Animal flow must be restricted to ensure that only one animal is within the antenna's read range.
•
The location of the antenna in relation to metal bars or pipes needs to be considered. See the diagram in
•
- Troubleshooting
.
The positioning of the antenna is important to obtain an effective read of the EID tag:
•
Antenna
After you have installed the antenna and reader, connect the antenna to the panel reader. An extension lead may be
required (supplied with the antenna).
Two antennas may be used, or the panel reader may be synchronised and used with another panel reader.
For more information, see the
Front of crush/chute,
weigh crate or drafter
Animal flow inside
crush/chute, weigh
crate or drafter
XRP2 Panel Reader and Antenna User Manual
XRP2 Panel Reader
Tru-Test Antenna
Tru-Test Indicator
Read zone
Antenna
.
EID Tag
Section 10
Keep animals
out of this area.
Animals inside
this area could
adversely affect
read performance
and may damage
the antenna
3