19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
27.Vacuuming dust and residues of construction causes immediate loss of warranty. The
vacuum cleaner is designed for domestic use only.
28. The device is outfitted with a rechargeable battery. Do not throw into a fire, puncture,
crush or damage the battery.
Device Description:
1. Dust tank 2. Filter 3. Dust tank release button 4. On / Off switch 5. LED light 6. Plastic cover 7. Hepa filter
Attachemnts:
8. Round Nozzle, 9. Flat nozzle 10. Charging base 11. Plastic Brush 12. Hose 13. Small round brush 14. Sofa brush 15. Plastic tubes
Charging the device.
Insert the adaptor into the mains socket. Always make sute the device is turned off before connectring to the power adaptor.
In order to ensure that the device is always ready for use, leave the device charging when not in use.
The adaptor may become warm during charging. This is normal.
Indicator light:
1. When charging. The indicator light will change color to blue and keep flashing. When fully charged it will stop blinking and will keep a
steady blue light.
2. When in use. The indicator light will shine a blue color.
3. When the battery is weak. The last remaining indicator light will keep flashing signaling you should charge it.
Using.
WARNING. DO NOT USE THE DEVICE WHILE CONNECTED TO THE POWER ADAPTOR.
1. Insert the nozzle/ connector/ round brush / hose into the main unit. Please check if there is any foreighn objects on the end part of the
device to make sure nothing will scratch or damage the cleaned surface.
2. Start the device by pressing the On / Off switch (4)
3. Push the on / off burron (4) to turn off the device after finishing work.
Attachments:
To put any attachments please use the Round Nozzle (8) and then put onto the nozzle the listed attachments in any configuration:
Plastic Brush, Hose, Small round brush, Plastic tubes.
Only the flat Nozzle(9) can be insterted directly into the Dust tanks inlet slot located in the front of the device.
Emptying / Cleaning.
Please do this very delicatly so the contents of the filter and the container do not spill. It is advised to do this over a rubbish bin or outside
where the tiny particles of the dust will not dirty the cleaned area.
1. Press the dust tank release button (3)
2. Gently push the dust tank(1) downwards to release it from the main unit.
3 Push your fingers into the hole of the hepa filter and gently pull out the Hepa filter (7) and the dust cover (6)
4. Throw away the contents of the dust tank.
4