PROFLO PFX308 Instrucciones Para La Instalación

Installation Instructions
PFX308 and PFXB304
Two Handle Kitchen Faucet
Fig. 1 Faucet installation
1.For replacement applications, ensure that the
water supply is turned completely off at the supply
valve before attempting remove and replacement
of the existing faucet.
2.For replacement applications, ensure the sink
deck is clear of any surface dirt or debris before
setting the new faucet in place. On an uneven
surface, use silicone sealant to seal the faucet
to the deck.
3.Using the included brass locknuts (No.17) ,
secure the faucet to the deck, making sure that
the faucet secures tightly to prevent any
movement or shifting.
4.Connect the hot cold water supply
connectors to the appropriate inlet. If you
are using coned supply risers, use the brass
coupling nuts (No.19) included with
the faucet kit. For installations employing
other types of supply connectors, consult the
manufacturer's installation instructions.
NO. Part Title Material
1 Faucet Body Low-lead Brass
2 Oring NBR
3 Connector Low-lead Brass
4 Nylon Ring Nylon
5 Spout Nut Brass
6 Spout Low-lead Brass
7 Washer NBR
8 Areator POM
9 Areator Housing Brass
10 Cold Cartridge Low-lead Brass
11 Hot Cartridge Low-lead Brass
12 Bonnet Brass
13 Handle Zinc
14 Blue Washer POM
15 Red Washer POM
16 Set Screw Brass
17 Mounting Nut Brass
18 Cone Washer PVC
19 Coupling Nut Brass
© 2012 Ferguson Enterprises, Inc. All Rights Reserved
5.To install the spout, insert the spout assembly
into the receiver of the spout canopy (No.6.)
6.Thread the spout nut onto the spout canopy
and tighten using an appropriately sized wrench.
7.Turn the water on and check for leaks. To
correct for leaks at a supply connection, gently
tighten the faucet coupling nut until the leak stops.
8.Turn the faucet on and check for adequate flow
rate. If flow rate is low, remove
aerator, flush and reassemble.
Distributed Exclusively by Ferguson and Wolseley Canada
PFX308
1
17
HOT IN
®
6
9
1/2"-14NPSM
COLD IN
CAP 13/07