ASROCK 890GM Pro3 Manual Del Usuario página 23

All manuals and user guides at all-guides.com
(9-pin USB6_7)
(see p.2 No. 13)
Infrared Module Header
(5-pin IR1)
(see p.2 No. 25)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2, No. 28)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].
System Panel Header
(9-pin PANEL1)
(see p.2 No. 23)
Chassis Speaker Header
(4-pin SPEAKER 1)
(see p.2 No. 24)
ASRock
This header supports an
optional wireless transmitting
and receiving infrared module.
This is an interface for the front
panel audio cable that allows
convenient connection and
control of audio devices.
This header accommodates
several system front panel
functions.
Please connect the chassis
speaker to this header.
890GM Pro3 Motherboard
2 3 2 3 2 3 2 3 2 3