General Instructions - Rampage AMP-772 Manual Del Propietário

All manuals and user guides at all-guides.com

GENERAL INSTRUCTIONS

PRECAUTIONS: IMPORTANT - READ THIS SECTION CAREFULLY
A. THIS UNIT IS NOT DESIGNED FOR USE WITH "FLOATING-GROUND" OR "BRIDGE-AUDIO" OUTPUT RADIOS
OR STEREO SYSTEMS. If in doubt, consult owner's manual of your stereo system or store where purchased.
Damage to stereo system and/or this unit may result if this unit is wired to a "Floating-Ground" or "Bridged-Audio"
system.
NOTE: If the owner's manual of your existing stereo radio/tape player advises NOT TO GROUND YOUR SPEAK-
ERS, you can be reasonably sure that the system is a Floating-Ground or Bridge-Audio type and should not be
used with this unit.
B. Due to the extremely high output power of this unit it is necessary that speakers having a minimum power rating of
20 watts be used. Use of lesser rated speakers may cause damage to speakers.
C. DO NOT ground any speaker to a metal part of the car. Use two wires for each speaker (one positive, one negative)
and return and splice all wires to the amplifier speaker output as shown in the wiring diagrams. Failure to follow this
wiring method will damage the amplifier.
D. Avoid operating unit at maximum power levels for prolonged periods as the speakers may be damaged.
E. This unit is designed for 12 volt DC negative ground electrical systems only.
SPECIFICATIONS
Output Power:
Frequency Response:
Output Impedance:
Operating Voltage:
80 watts maximum (40 watts x 2 channels)
50Hz-20,000 Hz. ±1 dB
4 or 8 ohm speakers
12 volts D.C., Negative Ground
-1-