Uline H-2051 Guia Del Usuario página 2

RECORDING PUSH BUTTON CODES
INTO INDICATOR RECEIVER
NOTE: Power to indicator must be ON.
RECORDING PUSH BUTTON (+):
1. Press and hold Mode Switch #1 (See Figure 3) for
about 3 seconds. Release the switch when the
green LED at the top of the receiver starts blinking.
Figure 3
2. Press the (+) button on the Wireless Push Button
Remote. The green LED will turn off to show that the
code is recorded.
PAGE 2 OF 6
OPERATION
RECORDING PUSH BUTTON (–):
1. Press and hold Mode Switch #2 (See Figure 4) for
about 3 seconds. Release the switch when the
red LED on the Receiver starts blinking.
Mode
Switch
#1
2. Press the (–) button on the Wireless Push Button
Remote. The red LED will turn off to show that the
code is recorded.
1-800-295-5510
uline.com
Figure 4
NOTE: A maximum of 15 codes can be
recorded per channel. To clear all codes, press
and hold Mode Switch #1 for about 3 seconds.
When the receiver's green LED starts blinking,
release Mode Switch #1, then press and hold
it again for 3 seconds. Repeat the procedure
with Mode Switch #2. Range of operation is up
to 30m (100 ft) or more from indicator.
Mode
Switch
#2
0421 IH-2051