Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. Dismantle the spare parts to be cleaned as possible as you can, and remove the dirt, oil
contaminants, carbon deposit etc. with a high-pressure jet, wire brush, scraper knife or other tools
so as to prolong the service life of the cleaning solution and ensure the cleaning speed and
performance.
2. Put the spare parts to be cleaned into the tank and make them fully-immersed, but not overlapped
as possible as you can.
3. Start Ultrasonic Cleaner:
a. Connect the power socket on the back to a power with the power cord. The red indicator lamp
will turns on and the LED screen will display "180".
b. Press the "TIME"
90-120-150-180-210-240-270-300-330-360-540-720-900 sec. then 18-21-24-27-30 min. and
then it starts again at 90 sec. (18 cleaning time in total).
c. Press "ON/OFF"
on, the setting time starts counting down.
d. When the time reaches "886", the machine stop working automatically. Besides, the ultrasonic
cleaning can also be stopped by pressing "ON/OFF"
e. Press "DEGAS"
circulation of 7-seconds cleaning and 1-second pause.
f. Unplug the power cord, pour the cleaning solution, clean the tank and the housing with a clean
cloth.
4. In order to enhance the cleaning effect, you can add appropriate amount of detergent into the
cleaning solution or prolong the cleaning time.
5. The machine will stop working after 45 minutes continuous work, and can started working again
after 4 minutes break.
TROUBLESHOOT
Problem:
Ultrasonic cleaning does not work
Reason:
The power cord is not connected
Solution:
Check the power connection and plug the power cord
Problem:
Ultrasonic cleaning does not work
Reason:
The fuse is burned
Solution:
Change the burned fuse with a good one of the proper voltage / ampere
Problem:
Ultrasonic cleaning does not work
Reason:
Other reasons
Solution:
Consult the after sale service department
Problem:
The time setting does not work
Reason:
Electronic problem
Solution:
Reset the power
Problem:
The time setting does not work
Reason:
Electronic problem
Solution:
Consult the after sale service department
Problem:
Bad cleaning effect
Solution:
Prolong the cleaning time
Solution:
Adjust the cleaning solution to a best cleaning level
Solution:
Choose the right detergent
ENVIRONMENTAL PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and
packaging should be sorted, taken to a recycling centre and disposed of in a manner which is
compatible with the environment.
DISPOSAL
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste
Electrical and Electronic Equipment. Contact your local solid waste authority for recycling
information or give the product for disposal to BGS technic KG or to an electrical appliances
retailer.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
button to switch the cleaning time in the following time circulation:
button once to start ultrasonic cleaning. The blue ultrasonic indicator turns
button once to start degas mode which makes the device be in a work
6
e
s
s
a r t S
h
c
s
m
e
R
button once again.
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
