Further Information; Energy Saving Tips - IARP GLOBO RETRÒ Serie Manual De Instrucciones

7.5 FURTHER INFORMATION

Take out packaging and clean all the cabinet using warm water together with 5% of neutral soap then dry it
with a soft cloth; for the glass parts only use specific products, avoiding the use of water which can leave on the
glasses limestone residues.
It is fundamental to comply with the distances indicated (cm) for correct installation of the equipment.
• Cabinet must be installed on a perfectly even surface, far away from any heat source (radiators, stoves, etc)
including sun rays.
• It is necessary that the capacitor unit is in the free air exchange condition, therefore the ventilation zones
must not be obstructed by boxes or otherwise.
• Install and position the unit in such a way so as to allow easy access to the power socket.
• Never place containers of liquid on or immediately above the ticket counter; should the content spill out, it
would damage the counter.
THE REFRIGERATOR IS NOT SUITABLE FOR WORKING IN DANGEROUS ENVIRONMENT WITH RISK
OF FIRE, EXPLOSIONS OR RADIATIONS.
Operation is regular with ambient temperature indicated on technical data plate.

7.6 ENERGY SAVING TIPS

• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so
on) and in a position out of direct sunlight.
• Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the
appliance causes an increase in energy consumption and reduces cooling efficiency.
• The internal temperatures of the equipment depend on the room temperature, the frequency the covers are
opened and the point in which the equipment is positioned. These factors must be taken into consideration
when you set the thermostat. Open the covers as little as possible.
• Let hot food and drink cool down before placing them in the appliance.
10 10
10
-25-