Flame Adjustment - Matco Tools SK12PR Guia Del Usuario

Important: Please read these instructions carefully to
familiarize yourself with all parts before filling with butane.
Keep these instructions for future use.
INSTRUCTION
The soldering iron has 3 different angles for multiple uses
by pressing the left and right buttons simultaneously.
IGNITION
1. Make sure the exhaust vent is facing away from objects.
2. Press the safety lock button simultaneously while using
your thumb to pull down the trigger. This action will
ignite the soldering iron.
3. Hold the ignition button and release the safety lock
button once lit. Move the continuous flame
switch to the right for a constant flame.
EXTINGUISHING
Move the continuous flame Switch left, this will cut off the gas supply and extinguish the flame.
HOT AIR
When cool to the touch, remove the soldering tip by rotating the tip counterclockwise.
The soldering iron can now be used as a hot blower without the soldering tip.
Operation will be the same as above for the soldering iron.
CAUTION: When assembling the parts, be cautious of being burnt by the soldering iron.
BUTANE TORCH
Disassemble the soldering assembly by rotating the assembly lock counterclockwise. Take off the soldering
device and install the metal sleeve back on to the unit. Operation will be the same as above for the soldering iron.

FLAME ADJUSTMENT

Move the adjustment lever to the right side to increase the flame strength or to the left to
decrease the flame strength.
When the lever is at the #4 position,
the longer flame may cause the
torch to flare or extinguish.
In this situation, please move
the gas adjustment lever
back to the #1 side to decrease
the flame strength and optimize
the flame efficiency.
INDEXING PENCIL & RIGHT
ANGLE BUTANE SOLDERING KIT
Page 2
SK12PR
Press the buttons
on both sides
simultaneously.
2011254-14