Silvercrest SWR 300 A1 Manual Del Usuario E Información De Servicio página 64

SilverCrest SWR 300 A1
Configuring WAP mode
WAP mode (Wireless Application Protocol) is used to extend your network or to make your
network available in another location.
Set up WAP mode as follows:
 Plug the wireless repeater into a suitable power socket.
 Connect a network cable to the LAN socket (6) of the wireless repeater. Insert the other end of
the network cable into a free LAN socket on your computer.

Click on
Wizard on the Home
page of the wireless repeater's
configuration menu and select
WAP mode. Then click on Next.

Here you can determine the
SSID (network name) and the
Security mode. In Security
mode, select the desired form of
encryption (WPA,
WPA/WPA2 mixed).
encryption is
password must be entered.
You can specify the SSID of the router and thereby extend the
network or set-up an independent Access Point. When entering the
router's SSID, ensure that this corresponds to the encryption of the
router.
62 - English
WPA2 or
If the
activated, the