Adjusting The Lowering Speed Of The Rotary Plate; Unloading - Jung JLA-e 5/12 G Manual De Instrucciones

4.6.11 Adjusting the lowering speed of the
rotary plate
1
1
> Loosen screws (1) and remove the cover (2).
> Turn the wheel (3) until the desired lowering speed
is set.
Increase lowering speed:
> Turn the wheel (3) in the (+) direction.
Reduce the lowering speed:
> Turn the wheel (3) in the (-) direction.
- 54 -
Electrically driven trolleys JLA-e 5/12 G with stroke and JLA-e 15/30 G with stroke

4.6.12 Unloading

> Secure the rear trolley with wedges.
> Raise the front edge of the transport load and
1
remove the electrically driven trolley.
> Place supports under the front edge and carefully
lower.
2
> Lift the rear edge of the transport load and remove
both cassettes of the adjustable transport trolley.
> Slowly and carefully lower the rear and front edges
alternately.
3
To lower a load, perform the steps in the
"Loading the trolleys" chapter, page 52,
in reverse order.
© JUNG Hebe- und Transporttechnik GmbH