Endress+Hauser Hart RN221N Manual Del Usuario página 40

Mode
Device does not react to
the set status
®
HART
operation
Device reports an error
even though the trans-
mitter does not return
any error
40
Effect
The transmitter does not
set the masked bit
The HART
cation to the transmitter
is interrupted
The wrong status bit was
masked
Cause Fault elimination
Check the assignment of
the status bits in the
Operating Instructions of
the transmitter
®
communi- Check whether there are
additional HART
ters in the HART
work and whether these
are configured correctly
(primary or secondary
master)
Check the assignment of
the status bits in the
Operating Instructions of
the transmitter
®
mas-
®
net-