Setting The Clock; Setting The Timer; Using The Scale - Duronic KS4000 Manual De Instrucciones

Ocultar thumbs Ver también para KS4000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Replacing the
batteries
Remove the cover of the battery compartment on the back of the scale.
Take out the old batteries and and replace with 2 new ones, ensuring that they are
positioned according to the correct polarities +/-.
Fix the back cover back on top of the battery compartment.
When discarding of old unwanted batteries, it is important to follow local recycling
guidelines to ensure they are disposed of safely and responsibly.
When the batteries are inserted, the time will need to be reset. On the digital display it
will flash "TM" to show it is in Time Setting Mode.
To set the time:
1. Press the "HRS" button to select the hour figure.
2. Press the "MIN" button to select the minute figure.
3. Press the "SET" button once to confirm the time you have selected, and the "TM" will
stop flashing.
4. The display will only show in the Time Setting Mode for 20 seconds if there is no
operation.
Note: 24hr clock display format will be shown only when the grams (g) unit is selected.
12hr clock display format will be shown only when the pounds (lb) unit is selected.
1. Press the "SET" button to enter the Timer Mode, the display will then show "0:00"
and "TMR".
2. Press and hold the "SET" button for 2 seconds to enter the Timer Set Mode and
'TMR' will flash.
3. Press the "HRS" button to adjust the hour figure.
4. Press the "MIN" button to adjust the minute figure.
5. Press the "SET" button once to confirm and 'TMR' will stop flashing. The time will
now begin counting down.
6. When the time counting has fnished, you will hear a beeping for 20
seconds. 7. Press "HRS" or "MIN" or "SET" to stop the alarm.
8. The scale will return to Clock Mode 40 seconds after the
alarm.
To Weigh
1. Place your scale in an upright position.
2. Press the ON/OFF button to switch on the scale.
3. Wait until the screen display shows
"0.0"
4. Press UNIT button to select the desired unit.
Batteries

Setting the Clock

Setting the Timer

Using the Scale

6

Publicidad

Tabla de contenido
loading

Tabla de contenido