Descargar Imprimir esta página

HON 94000 Serie Instrucciones De Instalación

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

BOOKCASE
Illustration 1
Bottom of
bookcase
Glide insert
Glide
Illustration 2
Wall
Front of bookcase
1
/
"
8
Four glides
Read all instructions and review illustrations
before installing.
Tools required for assembly:
24" long level
Tape measure
Assembly hardware pack contains:
(4) Glide
WARNING
Wood products are heavier than they appear and
may be hard to control when moving. Use two or
more people when moving wood products or
severe personal injury may result.
Leveling Glide Installation (refer to Illustration 1):
1. Use two or more people to lay bookcase flat on
cardboard or a carpeted surface (this is to prevent
the finish from being scratched).
2. Thread a glide (from hardware pack) into each
glide insert (from hardware pack) by turning glide
clockwise until glide is flat against insert.
3. Locate four holes in bottom of bookcase. Use the
rubber mallet to install a glide/glide insert assem-
bly into each hole.
Positioning and Leveling Bookcase (refer to
Illustration 2):
1. After glides are fully installed, use two or more
people to set bookcase upright and position book-
case into the location where it will be used.
2. Adjust the glides, on bottom of bookcase, until
bookcase is level from side-to-side. Use the 24"
long level to verify bookcase is level.
3. Adjust front glides so front of bookcase is
er than the rear. Use the tape measure to verify
1
front of bookcase is
/
Rubber mallet
(4) Glide insert
1
/
" high-
8
" higher.
8
242-2515E
(8/09)

Publicidad

loading

Resumen de contenidos para HON 94000 Serie

  • Página 1 BOOKCASE Illustration 1 Read all instructions and review illustrations before installing. Bottom of Tools required for assembly: bookcase 24" long level Rubber mallet Tape measure Assembly hardware pack contains: (4) Glide (4) Glide insert WARNING Glide insert Wood products are heavier than they appear and may be hard to control when moving.
  • Página 2 MEUBLE BIBLIOTHÈQUE Illustration 1 Lire toutes les instructions et examiner les illus- trations avant d’installer. Outils nécessaires pour le montage : Dessous du Niveau de 24 po de longueur meuble Mètre ruban bibliothèque Le paquet de matériel de montage comprend : (4) Glissière (4) Chaque douille ATTENTION...
  • Página 3 LIBRERO Figura 1 Lea todas las instrucciones y revise todas las fig- uras antes de instalar. Herramientas necesarias para el montaje: Parte inferior Nivel de 24" de largo del librero Cinta de medir Este paquete de piezas de montaje incluye: (4) Pata niveladoras (4) Cada encastre ADVERTENCIA...

Este manual también es adecuado para:

Hon94225nn