Publicidad
Idiomas disponibles
Idiomas disponibles
position. If the heater is required to run continuously, set
the slide switch on the timer to the position indicated by
(I).
5.
To override the timer action slide the switch to either
(0) for heat off or (1) for heat on. The clock timer will
continue to run but will no longer control the heater.
OPERATION with TIMER in "I" (ON)
position
•
Make sure HEATER switches are also in an ON position
for the appliance to warm up and set the THERMOSTAT
dial to the desired temperature level. (NOTE at MINIMUM
'Frostguard' setting the unit will only function when the
ambient room temperature drops below around 7 degrees
centigrade)
•
With heater switches in the OFF position the unit will not
warm up, even when the TIMER is in the 'I' (ON) position
36
Publicidad
