Emission Levels; Technical Data; Intended Use - fest T18+3 Manual De Instrucciones Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
English
pipe can lead to an explosion. Penetration
of a water pipe can result in damage to
property.
Wear suitable personal protective equip­
ment: Ear protection and safety goggles.
CAUTION! Power tool can jam and cause
sudden kickback! Switch off immediately!
Hold the power tool firmly in your hand.
Make sure the speed is adjusted correctly
when screwdriving. Be prepared for a high
reaction torque, which may cause the pow­
er tool to turn and possibly lead to injury.
Do not use the power tool in the rain or in
damp surroundings. Moisture in the power
tool may cause a short circuit and fire.
Do not lock the on/off switch in place per­
manently.
Do not use power supply units or third-
party battery packs to operate cordless
power tools. Do not use third-party charg­
ers to charge the battery packs. The use of
accessories not expressly authorised by the
manufacturer can result in electric shocks
and/or serious accidents.
Only for AS/NZS: The tool shall always be
supplied via residual current device with a
rated residual current of 30 mA or less.
2.4

Emission levels

The levels determined in accordance
with EN 62841 are typically:
Sound pressure level
Sound power level
Uncertainty
CAUTION
Noise generated when working
Risk of damage to hearing
► Use ear protection.
4

Technical data

Cordless drill
Motor voltage
No-load speed*
14
Vibration emission level a
three directions) and uncertainty K measured in
accordance with EN 62841:
Drilling in metal
Fastening
The specified emission levels (vibration, noise)
The emission values may deviate from the
specified values. This is dependent on how
the tool is used and the type of workpiece
being machined.
► The actual load during the entire operating
► Depending on the actual load, suitable pro­
3
Cordless drill suitable
L
= 64 dB(A)
PA
L
= 75 dB(A)
WA
K = 5 dB
ded use; this also includes damage and wear
caused by continuous industrial operation.
are used to compare machines.
They are also used for making preliminary
estimates regarding vibration and noise
load during operation.
They represent the primary applications of
the power tool.
CAUTION
cycle must be evaluated.
tective measures must be defined in order
to protect the operator.

Intended use

for drilling in metal, wood, plastics and
similar materials,
for screwing in and tightening screws.
intended for use with BP Festool battery
packs of the same voltage class.
The user is liable for damage and acci­
dents caused by improper and non-inten­
1st gear
1st gear 0 - 1500 rpm
(vector sum for
h
a
= 2,7 m/s
2
h
K = 1,5 m/s
2
a
< 2,5 m/s
2
h
K = 1,5 m/s
2
T18+3
18 V
0 - 450 rpm

Publicidad

Tabla de contenido
loading

Tabla de contenido