• Prevent exposing the FM transmitter to
high temperatures (above 60° C). Protect it
from direct sunlight and keep it away from
sources of heat
FCC RulES
You are cautioned that changes or modifica-
tions not expressly approved by the part
responsible for compliance could void the
user's authority to operate the equipment.
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 5 of the FCC rules.
These limits are designed to provide reason-
able protection against harmful interference
in a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation.
If this equipment does cause harmful interfer-
ence to radio or television reception, which can
be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equip-
ment and receiver.
-Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
operation is subject to the following two
conditions:
) This device may not cause interference and
) This device must accept any interference,
including interference that may cause
undesired operation of the device
FCC RF radiation exposure statement:
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. End users must follow the
specific operating instructions for satisfying RF
exposure compliance. This transmitter must not
be co-located or operating in conjunction with
any other antenna or transmitter.
7