memorex Disneys The Little Mermaid DCD6011-MER Guia Del Usuario

SAFETY PRECAUTIONS
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol within
an equilateral triangle is intended to alert the
user to the presence of uninsulated dangerous
voltage within the product's enclosure that may
be of sufficient magnitude to constitute a risk of electric shock
to persons.
ATTENTION:
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
DANGER:
This product utilizes a Class 1 laser to read
Compact Discs. This laser Compact Disc player
is equipped with safety switches to avoid
exposure when the CD door is open and the
safety interlocks are defeated. Invisible and hazardous laser
radiation when open and interlock failed or defeated. Avoid
direct exposure to beam. Please do not attempt to defeat or
bypass the safety switches.
FCC WARNING:
This equipment may generate or use radio frequency
energy. Changes or modifications to this equipment may
cause harmful interference unless the modifications are
expressly approved in the instruction manual. The user
could lose the authority to operate this equipment if an
unauthorized change or modification is made.
INFORMATION:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installa-
tion. This equipment generates, uses and can radiate radio fre-
quency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
• Do not open the CD compartment while the CD is rotating.
• Always keep the CD compartment closed when not in use.
• Keep all foreign objects out of the CD compartment.
• Place the unit on a stable surface.
• Avoid installing the unit in locations described below:
• Places exposed to direct sunlight or close to heat radiating
appliances such as electric heaters.
• On top of other stereo equipment that radiates too much
heat.
• Places lacking ventilation or dusty places.
• Places subject to constant vibration.
• Humid or moist places.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty
for this product.
ATTENTION:
POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA
LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRE-
SPONDANTE DE LA PRISES ET POUSSER JUSQU'AU FOND.
This Class B digital apparatus complies with Canadian ICES-
003. / Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
All manuals and user guides at all-guides.com
MODEL: DCD6011-MER
OWNER'S MANUAL
LOCATION OF CONTROLS
1. Headphones 1 Jack
(Side of Unit)
2. Headphones 2 Jack
(Side of Unit)
3. SKIP/SEARCH (o)
Button
4. VOLUME Control
5. SKIP/SEARCH (n)
Button
6. PLAY/PAUSE
(®p)/POWER ON
Button
7. DBBS Switch
POWER SOURCES
BATTERY INSTALLATION
The battery low indicator will blink in the
display when the batteries need replacing.
1. Open the Battery Compartment door
(inside the CD compartment) by
pressing in on the tab and then lifting
up. To prevent the possibility of
losing the cover, it cannot be removed.
2. Insert two (2) "AA" batteries (not included) according to
the polarity diagram inside the Battery Compartment.
Alkaline batteries are recommended for the longest
playing time.
AC OPERATION
To operate the unit using AC power, connect an AC
adapter (not included) to an AC outlet having 120V, 60Hz
AC only. Plug the small end into the DC 4.5V jack on the
rear of the unit and connect the other end into an AC outlet.
The batteries are automatically disconnected when an AC
adapter is used. CAUTION: When not using AC power,
disconnect the AC adapter from the wall outlet by pulling
the plug (not the cord). Do not touch the AC adapter with
wet hands. Fully insert the plug without exposing any part
of the blade.
OPERATION
60 SECOND MOTION PROOF ELECTRONIC
ANTI-SHOCK SYSTEM
This CD player has a built-in Anti-Shock System that cuts down
on CD skipping, which is useful when using the CD player in
the car or while jogging/walking. Anti-Shock is automatically
activated when the unit is turned on. To turn the Anti-Shock
System off, press the ESP button once; the ESP indicator will
disappear.
HEADPHONE JACKS
There are two Headphones jacks. Plug headphones in one jack
for private listening or both jacks for sharing.
TO PLAY A CD (Standard, CD-R and CD-RW)
1. Open the CD compartment door by sliding the CD OPEN
switch to the right. Gently press a disc, label side up, onto
the spindle until it locks in place. Close the CD compartment
door. Insert headphones into the Headphones jack.
2. While the unit is off, press the PLAY/PAUSE (®p)/ POWER
ON button to start playback. To pause playback, press
the PLAY/PAUSE (®p)/POWER ON button again, the
elapsed time will blink. Press once again to resume
playback.
3. Adjust the VOLUME control and DBBS switch (to
enhance the bass) as desired. To skip forward or
backward through the tracks on the disc, press the
SKIP/SEARCH O or N button. To search forward or
backward through the tracks on the disc, press and hold
the SKIP/SEARCH O or N button.
4. When the disc is through playing, it will stop. Press the
STOP (I)/POWER OFF button to stop the disc before it is
finished; the total number of tracks will appear. Press the
STOP (I)/POWER OFF button again while in the Stop
mode to turn the unit off or wait approximately 30 seconds
and the unit will automatically turn off.
NOTES:
8. DC 4.5V Jack
• This unit is capable of playing standard CDs or 3" singles;
no adapter is required.
(Rear of Unit) Z
• If a disc is inserted incorrectly, dirty, damaged or not
9. CD Compartment with
present at all, the display will show "disc".
Battery Compartment
• As each track is played, the track number and elapsed
(inside)
time are shown in the display.
10.Display • To remove the disc, open the CD compartment while the
unit is in the Stop mode or off, then hold the edge of the
11.MODE Button
CD, gently press the center pivot and lift the CD.
12.PROG (Program)
• The display will show "OPEN" when the CD compartment
Button
door is open.
13.ESP (Anti-Skip
Protection) Button MODE PLAYBACK
1. With a CD inserted, press the PLAY/PAUSE (®p)/
14.STOP (I)/POWER
POWER ON button to turn the unit on, then select a track
OFF Button
using the SKIP/SEARCH O or N button (if desired).
15.CD OPEN Switch
2. Press the MODE button once; the Repeat 1 indicator
1 will appear in the display. The unit will then play the
same track over and over until the STOP (I)/POWER
OFF button is pressed.
3. Press the MODE button a second time; the Repeat All
indicator
then play all the tracks on the CD over and over until the
STOP (I)/POWER OFF button is pressed.
4. While in the Stop mode, press the MODE button three
times; the INTRO indicator will appear in the display.
Press the PLAY/PAUSE (®p)/POWER ON button and
the unit will play the first 10 seconds of each track. Press
the STOP (I)/POWER OFF button to stop Intro playback.
5. While in the Stop mode, press the MODE button four
times; the RAND indicator will appear in the display. The
unit will play all the tracks in random order. When all the
tracks have been played, the unit will stop. Press the
STOP (I)/POWER OFF button to stop Random playback.
6. Adjust the VOLUME control and DBBS switch as desired.
TO CANCEL Mode Play, press the Mode button until the
indicators disappear.
TO PROGRAM THE MEMORY (UP TO 20 TRACKS)
1. While in the Stop mode, press the PROG button. The
track number will blink and "01" will appear in the display.
2. Select a track to be programmed using the Skip/
SEARCH O or N button.
3. Press the PROG button to memorize the track. Repeat
Steps 1 and 2 to program additional tracks up to a
maximum of 20 tracks.
4. Press the PLAY/PAUSE (®p)/POWER ON button to
begin Program playback.
NOTES:
• You can review the program by pressing the PROG
button repeatedly while in the Stop mode.
• Press the STOP (I)/POWER OFF button to stop the
program before it is finished (the program memory will be
kept). Press the STOP (I)/POWER OFF button to turn
the unit off and clear the Program memory.
• Each track may be stored in the program memory as
many times as desired (up to 20 files).
• You can scroll through the program while it is playing
using the Skip/Search O or N button.
WARRANTY: 90 days parts and labor. For additional warranty
information
www.disneyelectronics.com or contact customer service at (954)
660-7026. Please keep all packaging material for at least 90 days in
case you need to return this product to your place of purchase or
Memcorp. For parts and accessories, contact Fox International at
1-800-321-6993. Distributed by Memcorp Inc., Weston, FL, Disney
Elements © Disney 2006.
"A"
English
ALL
will appear in the display. The unit will
ALL
or operating assistance, please visit