Troubleshooting - Packard EHR-2080 Guia Del Usuario

T
ROUBLESHOOTING
Problem Solution
•
•
No sound
•
No picture •
(Black screen)
•
•
•
No response
•
Remote control
•
does not work
•
•
•
•
•
Cannot play disc
•
•
•
•
Poor playing
quality (distorted •
picture/sound)
•
Packard Bell Easy HDD Recorder User's Guide
32 -
All manuals and user guides at all-guides.com
Connect the audio cables into the connectors securely.
Verify the connection from the HDD recorder audio output to the TV or
receiver audio input. Make sure the correct AUDIO input is selected on your
TV or amplifier.
Refer to your audio amplifier owners manual.
The scan mode of video output is incorrectly set. Press the PS/IS button on
the remote control to switch to correct mode.
Connect the power plug into the wall outlet securely.
Timer recording is active. Press Power or Stop to cancel time recording.
The appliance might have encountered a technical failure. Unplug the power
supply and wait for 30 seconds before connecting it to the wall outlet again. If
it still doesn't work, try to restore the Easy HDD Recorder to its factory set-
tings.
The remote control is not pointing at the Easy HDD Recorder. Please aim at
the Easy HDD Recorder.
Batteries are flat, replace batteries.
The appliance might have encountered a technical failure. Unload batteries,
wait for 30 seconds before place them back into the remote control.
Blank disc, replace the disc.
Incompatible disc: please refer to the list of supported disc types.
The disc is loaded with label side down. Make sure to load the disc with label
side up.
Wrong region code. The region code does not match the region setting of the
Easy HDD Recorder.
Parental lock is on. Unlock the parental lock. Default password is 3308.
Choose channel number on the TV set. Choose a correct channel number.
The connection between the Easy HDD Recorder and TV set is loose. Check
the connection.
The TV set is not adjusted to the best status.
The disc is dirty, clean the disc.
Interference may also make the picture distorted.