Air Source - BGS technic 18087 Manual De Instrucciones

SAFETY ADVICE
•
WARNING! Do not pollute the environment by allowing uncontrolled discharge of fluids.
•
WARNING! Brake fluid is flammable - keep away from sources of ignition, including hot
surfaces e.g. exhaust manifold.
•
WARNING! Brake fluid will damage paintwork. Any spillage should be flushed with water
immediately.
•
Do not leave brake fluid out in the open. Brake fluid is hygroscopic which means it will absorb
humidity out of the air. The existence of water in brake fluid will decrease its boiling point and
may cause a total malfunction of your brake system.
•
Always use new and unused brake fluid; used and worn out brake fluid may cause a total
malfunction of your brake system.
SPECIFICATIONS
Inlet air pressure: 6 - 12bar (87 - 174psi)
Container capacity: 1.0 litre

AIR SOURCE

Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.
Water in the air hose and compressor tank contributes to reduced performance and damage of the air
tool. Drain the air tank and filters before each use and as necessary to keep the air supply dry. Use
an in-line pressure regulator with gauge if air inlet pressure is critical.
RECOMMENDED AIR SYSTEM
No. Description
1 Air Tool
2 Air Hose
3 Quick coupler
4 Oiler
5 Pressure Regulator
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6 e s s a r t S
h c s m e R
Air consumption:
Thread connection:
No.
6 De-Watering / Filter Unit
7 De-Watering Valve
8 Shut-Off Valve
9 Dryer / Filter Unit
10 Compressor / 11 De-Watering Valve
Tel. +49 (0) 2191 / 46438-0
r e F ax +49 (0) 2191 / 46438-40 s u k r e v e
7 9 8 2 4 - D e
180 ltr/min
1/4" BSP (female)
Description
L
d . l h a t s w s @ o f n i : l i