Minnesota Fats MFT200CCAF Instrucciones De Montaje página 6

8 pcs - H2 Allen Head Bolt
8 pcs - H3 Flat Washer
12 pcs - H4 Phillips Round Head Screw
STEP 2:
With the help of another adult, align the holes in P4 End Leg Panels with the pre-drilled pilot holes
in the Legs and attach with H4 Phillips Round Head Screws as shown in Figure 2.
Important Note: Tighten, but do not strip out H4 Screws.
Attach P5 Side Leg Panels as shown using H2 Allen Head Bolts and H3 Flat Washers.
Use the T1 Allen Wrench to tighten the bolts.
ATTENTION:
THIS STEP REQUIRES FOUR OR MORE ADULTS.
VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON
ITS LEGS. BE CAREFUL. THE TABLE IS VERY HEAVY.
P5 Side
Leg Panel
P4 End Leg
Panel
Lastly, using a carpenter's level adjust the P6 Leg Levelers to properly level the pool table.
All Rights Reserved.
© 2016 Escalad e Sports
All manuals and user guides at all-guides.com
PARTS REQUIRED:
2 pcs - P4 End Leg Panel
2 pcs - P5 Side Leg Panel
1 pc - T1 Allen Wrench
H4
Screws
H2 Allen
Head Bolt
H3 Flat
Washer
T1 Allen Wrench
6
P4 End Leg Panel
Figure 2
Fo r Custome r Servic e Cal l 1-866-556-2757