Installing The Batteries In The Remote Control; Front Panel - LTC MFA1200-USB-BT Manual De Instrucciones

INSTALLING THE BATTERIES IN THE REMOTE CONTROL

•
Place the remote face down on a flat surface.
•
Push the compartment cover into the direction of the arrow.
•
Slide the battery compartment open.
•
Remove the old battery and install the new one (CR2032) with the plus (+) symbol facing up.
•
Gently slide the battery compartment closed. It locks automatically.
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in
accordance with your local regulations. Batteries shall not be exposed to excessive heat such as sunshine, fire or the
like. When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or cor-
rosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
The supplied remote control contains a button cell. In case of ingestion, it might cause serious internal burns within only 2
hours that might lead to death. Keep new and old batteries out of the reach of children. If you are in doubt whether the
batteries have been swallowed or introduced into any other part of the body, contact immediately a doctor.

Front panel

POWER: Press this button to power ON or OFF the unit
SD: Connect your SD card here
USB: Connect your USB flash drive here
Treble: Turn this knob to adjust the treble of main output
Bass: Turn this knob to adjust the bass of main output
Balance: Turn this knob to adjust the balance of main output.
MIC VOL: Use this knob to adjust the microphone volume
MIC1 & MIC2: Connect your microphones here
Input: Press this button to switch among all the inputs.
Play/Pause: Press this button to play the signal from USB/SD, Bluetooth. Press again to pause
IR: Infrared sensor to receive the signal from the remote control
Previous: Press this button to go back to the beginning of the current track or move to the previous track or
move to previous station.
Next: Press this button to move to the next track or move to next station.
Master Volume: Use this knob to control the master volume.
OPERATION
•
Select a central location for the amplifier.
•
Connect the speaker wires (red & black) to the + and – terminals on the rear panel of the amplifier.
•
Connect the audio signal to the relevant sockets with the correct polarity.
•
Plug the mains lead in and switch the amplifier on once you have checked all connections.
•
Switch the audio sources on and adjust the master volume to the required level.
•
Karaoke: Plug a mic into MIC1 or MIC2 socket on the front panel. Before you use the mic, make sure that it
is switched off and the MIC volume button is set to the minimum. Connect the microphone, switch it on and
adjust slowly the volume and the echo.
•
If you don't use the unit any longer, switch the amplifier off and disconnect it from the mains.
Signal Sources and their Connections:
•
Connect a DVD-player or a CD-player to the terminal AUDIO INPUT or a data storage unit to the USB-interface
MFA1200USB-BT (10-7006)
www.ltc-audio.com
3