Unitech Tashi MT200 Guia De Inicio Rapido página 8

Using Terminal Block
MT200 is designed with a 12-pin terminal block for input/output signals. To
install the 12-pin block, refer to the instruction made below.
1. Insert the stripped ends of the wires respectively into terminal block
sockets of the male plug (see the illustration made below), and then
tighten the lock screw to secure the wire.
2. Then, insert the terminal block
plug into the female socket of
MT200.
Copyright 2009 Unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of Unitech Electronics Co., Ltd.