Bogen NYQUIST NQ-A2060-G2 Manual De Instalacion Y Uso página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Viewing and Understanding LEDs
Two LEDs appear on the front of the amplifier. One is labeled POWER
and appears as solid red during initial power up, flashes green during
a boot sequence, and appears solid green when fully booted.
The STATUS LED uses the following
indicators to provide information
about the appliance:
FLASHING
No network connection found.
SOLID
BLUE
in an uninitialized state and is
not associated to a server.
(The server may be in a
discovery mode.)
SOLID
GREEN
normal operation.
FLASHING
is not registered with the Nyquist server.
SOLID
RED
so that the Nyquist application can resume.
FLASHING
Clipping, Protection, and Temperature Indicators
In addition to the LEDs that appear on the actual appliance, separate
amplifier module signal clipping, protection mode, and temperature
status indicators appear in the Nyquist amplifier's web-based user
interface.
For more information about these status indicators, refer to the
Nyquist Audio Power Amplifiers Configuration Manual.
RED
– The amplifier is
– The amplifier is registered to a Nyquist server and is in
GREEN
– The amplifier has an IP address but
– The amplifier needs to be rebooted or reset
BLUE
– The amplifier is updating.
NQ-A2060-G2 and NQ-A2120-G2

Publicidad

Tabla de contenido
loading

Productos relacionados para Bogen NYQUIST NQ-A2060-G2

Este manual también es adecuado para:

Nyquist nq-a2120-g2

Tabla de contenido