Publicidad
FUNCTIONS
BACK PANEL
1. LINE IN
Input connection using either XLR or 6.3mm
TRS Jack. Connect the outputs from a mixer or
PA speaker to this input.
2. LINK
Full range output connection using XLR.
Connect PA speakers from this output.
3. OUTPUT
Post-crossover, low range output. Connect
further subwoofers to this output.
4. REVERSE PHASE SWITCH
180º phase reverse function. If you find that the
overall sound seems low volume or thin when
using the subwoofer in conjunction with a PA
speaker, try using this function.
5. LEDs
SIG: When lit, the speaker is receiving an input
signal.
: When lit, the power is on.
6. MASTER LEVEL
Adjust the overall output volume.
7. CROSS OVER CONTROL
Change the high cut point of the low pass filter
to either 80Hz or 125Hz.
8. FUSE SWITCH
Change between 115V and 230V input power.
Please ensure the correct rating is used for your
region.
9. POWER SWITCH
Turns the speaker on or off.
10. POWER INPUT
Connect the provided AC power cable here.
5
Publicidad
