Preparing The System - Cardin ZVL614.00 Serie Manual De Instrucciones

433 MHz transmitters
TXQ449100
TXQ449200
TXQ449300
TXQ449400
TXQ44940M
TXQPRO449-4
TXQPRO449-4A
Receivers 433 MHz
RQM449200
RSQ449200
RSQ449OC2
RCQ449100
Memory module ZGB24LC16-I/P
The module is furnished with a none-volatile EEPROM type memory and contains the transmitter codes and allows
you to memorise up to 300 codes. The programmed codes remain stored even in the absence of power.
Attention! Removing and inserting the memory module must be carried out when the receiver is switched off
otherwise the memory content could become corrupt.

PREPARING THE SYSTEM

To obtain the best results from the radio control system the aerial installation site should be carefully chosen. 'Range'
is intended to mean the working distance, measured in free space, between the receiver and the transmitter with
the aerial installed. The range is therefore closely linked to the technical characteristics of the system and varies
according to the characteristics of the site in which the system is located. For best
to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial to the receiver using a coaxial cable RG58
(impedance 50Ω) with a maximum length of 15 m.
868 MHz transmitters
TXQ486100
TXQ486200
TXQ486300
TXQ486400
TXQ48640M
TXQPRO486-4
TXQPRO486-4A
Receivers 868 MHz
RQM486200
RSQ486200
RSQ486OC2
RCQ486100
Description
1-channel transmitters
2-channel transmitters
3-channel transmitters
4-channel transmitters
4-channel wall mounted transmitters
4-channel industrial transmitters
4-channel industrial transmitters + aerial
Description
2-channel mini receivers
2-channel slot-in receiver cards
2-channel slot-in receiver cards open collector
4-channel outdoor receivers
10
performance we advise you