SNOWJOE SUNJOE iON100V-16ST-CT Manual Del Usuario página 18

Troubleshooting
Problems Possible Cause
The motor does not • Battery is not inserted well or is flat.
run or the tool runs
• Spool housing cannot rotate freely.
slowly.
• Cutting line does not protrude.
Line fails to cut off. • Line cutter in guard is covered,
• Line extends past guard.
damaged, or missing.
Possible Solution
• Check to make sure the battery is charged and inserted
well.
• Remove the spool and clean the slots; carefully remove
any grass and weeds or other debris.
• Cut the spool line off so that it just reaches the line
trimming blade.
• Contact your authorized Snow Joe
or call Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563) if the trimmer does
not start after completing these checks.
• Contact your authorized Snow Joe
or call Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563).
• Rewind or trim line to line cutter.
18
+ Sun Joe dealer
® ®
customer service center at
®
+ Sun Joe dealer
® ®
customer service center at
®