Tips And Tricks; Cleaning And Maintenance - Wilfa IMMIX Manual De Instrucciones

TIPS AND TRICKS

TIPS ON ICE CRUSHING
• By adding water to the ice, you get a better crushing performance.
• If the ice sticks to the jug during crushing, it should be added some water.
You can also try to give the jug a gentle knock to get the ice to fall down to
the knifes.
TIPS ON BLENDING
• If you like to use hard seeds or other food which is difficult to blend, you
should try to blend these ingredients as they are, without fluid. If the
blending does not work, add fluid in small portions until it blends well.
• If the ingredients are too dry, the ingredients might not get in good contact
with the knives, so the knives don't get hold of all the ingredients. You can
help this by add fluid and reduce the speed to minimum and give the jug a
gentle knock to help the ingredients to fall down to get in good contact with
the knifes so the blending will work well.
More tips, recipes and tricks can be found on www.wilfa.com or our local web
sites.

CLEANING AND MAINTENANCE

• Disconnect the power from main supply.
• Disassemble all removable parts before cleaning.
• Always clean the removable parts immediately after use.
• Clean all removable parts in lukewarm water with dishwashing liquid.
• The blender jug can be rinsed with water. It can also be cleaned by pouring
water into the blender jug, closing the lid and then operating the blender
in Auto clean. Then pour out the water, rinse with water, and dry with a soft
cloth.
• Use dry cloth to clean the main body.
Note: Be careful when cleaning the parts. Avoid touching the sharp blades!
After cleaning, repack the appliance and store it in a dry place and avoid sun
exposure.
BLENDER · BL7S-PB1800
9
EN