Publicidad
Idiomas disponibles
Idiomas disponibles
Windscreen Removal Tool Set, 7 pcs.
TOOLS
1 Panel Removal Tool
2 Cutting Wire Holder / Handle
3 Piercing Awl
APPLICATION
1. Remove all panels which are inside within the range of the adhesive material with the removal
tool (1).
2. Unwind some cutting wire (4) and push it through the adhesive material by using the piercing awl
(3). In case of narrow space, heat up one tip of the cutting wire with a lighter and gently push the
hot wire through the adhesive material. Therefore you need to hold the wire with a pliers.
3. Shorten the cutting wire to desired length.
4. Attach the tips of the wire to the handles (2) by pushing the wire through the lower opening of the
hollow shaft (fig. A) until it can be inserted into the bore hole at the upper part of the shaft (fig. B).
Snap the wire and push back the shaft into its handle (fig. C).
5. By going back and forth, the wire heats up and starts working through any adhesive material.
6. ATTENTION when working in narrow space. The cutting wire can damage painted surfaces and
covering panels.
7. Residual fillers or adhesives can be removed by using either the double hook handle (5) or the
pull scraper (6).
Abb. A
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
Abb. B
6
e
s
s
a r t S
h
c
s
m
e
R
4 Cutting Wire
5 Adhesive Material Cutter
6 Pull Scraper and Pull Rope
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
60300
Abb. C
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
