Cleaning And Maintenance - Starlyf RADIANT HEATER Manual De Instrucciones

1 2 3 4 5
A wall mounting bracket is provided with the heater, which has
been specifically designed to allow this product to be attached to
a wall. Before drilling the holes for the wall mount, ensure that
the surface is solid and that there are no hidden water pipes or
electric wires.
The heater must be installed no less than 40 cm from side walls
and no less than 40 cm from the ceiling.
Important: Ensure that the supply cable is well secured and that
it does not come into contact with the reflector of the heater and
that it does not hang in the heated area. Plastic zip ties can be
used to securely
attach the supply
cable to the metal
mounting bracket
behind heater.
4
min. 400 mm
min. 400 mm
min. 1800 mm
The heater
installed at least 1.8 m
above the floor.
REMOTE CONTROL INSTRUCTIONS
OPERATION
1. PLUG the unit into a power supply socket. Ensure
the power supply is suitable for the product.
2. PRESS the power button on the right side of heater.
Or you may have to switch the button to L1 or L2.
3. SWITCH ON the heater by remote control or switch
it on manually.
4. Use the DOWN & UP BUTTONS on the remote
control to set the heat output level.
Operation: press the ON/OFF button, then press the
heat level (L1, L2, standby, off)
Remote Control Function
Button Function (Heater On) Function (Heater Off)
Switches heater on
O
or off
Power setting Turns heater on to
I
Level 1 (50% power)
Power setting Turns heater on to
II
Level 2 (100% power)
Note: All Starlyf® Radiant Heaters and their remote controls have
the same frequency, so it is possible to control several heaters with
just one remote control.
The POWER BUTTON on the right of heater can be manually operated
without using the remote control.
Inserting Batteries (not included)
must be
Insert 2 AAA alkaline batteries into your remote control handset.
1. Remove the battery cover on the back of your remote control. Insert
the batteries in accordance with the instructions and polarity markings.
2. Change the batteries as shown above.
Product data:
Model VVAVACIND1156
Voltage (V) 220-240 V AC
Wattage (W) 2000 W
Hertz (Hz) 50/60 Hz
Dimensions W×H×D (cm) 67.5x10.5x7.2 cm
Weight (kg) 1.7 kg

4. CLEANING AND MAINTENANCE

Regular and careful cleaning helps your infrared heater operate
efficiently for many trouble-free years. To clean your heater, follow
steps below:
1. Unplug the power cord from the mains for your safety before
cleaning the heater.
2. Make sure the heater is cool before continuing.
3. To keep the heater clean, the outer body maybe cleaned with a soft,
damp cloth. You may use a mild detergent if necessary. After cleaning,
dry the unit with a soft cloth. (CAUTION: DO NOT let liquids enter the
heater.)
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish
or rough brushes to clean the heater. This may cause damage or
deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the heater is completely dry before use.
Storage: Store the heater in a cool, dry place when not in use to
prevent dust and dirt build-up. Store the heater in the original box.
Troubleshooting
1. If heater will not start up, the cord is probably not plugged into an
electrical outlet. Plug it into an electrical outlet.
2. Ensure that the mains electricity is working.
3. The lights are on, but there is no heat. Solution: the bulb is damaged.
Purchase a replacement bulb from your local dealer.
5. QUALITY WARRANTY
This product is covered by a warranty against manufacturing defects
subject to the time periods stipulated by the legislation in force in each
country.
This warranty does not cover damage resulting from inadequate use,
negligent commercial use, abnormal wear and tear, accidents or
improper handling.
CAUTION
DISPOSAL OF MATERIALS
A symbol of a crossed-out wheeled bin means you should find
out about and follow local regulations about disposing of this
kind of product.
Do not dispose of this device as you would other household waste.
Dispose of this product in accordance with the corresponding local
regulations.
Electrical and electronic appliances contain hazardous substances
that can have harmful effects on the environment and/or human health
and should be recycled properly.
Australia & New Zealand only
This product has the benefit of certain Consumer Guarantees. These
are prescribed by the Australian Consumer Law & the New Zealand
Consumer Guarantees Act 1993 both of which provide protection for
consumers. There is no express warranty for this product in Australia
or New Zealand. The above paragraph refers to other countries.
Made in China
5